blank code for cpu1 and general steps

epwm_cpu1_bitfield/epwm_cpu1_bitfield_main.c

@@ -0,0 +1,36 @@
+/* Gerardo Marx
+21/Oct/2026
+Objective:
+- ePWM1 (ePWM1A and ePWM1A) and ePWM2 will be controlled CPU1
+- ePWM4 and ePWM5 will be controlled CPU2
+- CPU1: ePWM1 (GPIO0 and GPIO1 outputs), up-count, 10KHz, and D=0.4
+- CPU1: ePWM2 (GPIO2 and GPIO3), up-down, 5KHz, and m=-0.3
+- CPU2: ePWM4 (GPIO6 and GPIO7), up-count, 15KHz, and D=0.6
+- CPU2: ePWM5 (GPIO8 and GPIO8), up-down, 4KHz, and m=+0.7
+*/
+
+// libreries
+#include "F28x_Project.h"
+#include "driverlib.h"
+#include "device.h"
+
+// interrupts
+
+
+//main
+void main(void)
+{
+    // 1. Initialize the system and interrupts
+    // 2. Select the ePWM clocks and assign CPU ownership
+    // 3. Enable ePWM1 and ePWM2 clocks
+    // 4. Stop time-base synchronization
+    // 5. Configure TB and CC.
+    // 6. Configure AQ and dead band.
+    // 7. Configure event trigger and trip-zones.
+    // 8. Register and enable interrupts.
+    // 9. Configure PWM GPIOs, diagnostic pin, and X-BAR
+    // 10. Confirm fault condition and syncronize startup.
+
+    for(;;) { } 
+
+}

epwm_cpu2_driverlib/epwm_cpu2_driverlib_main.c

@@ -0,0 +1,19 @@
+/* Gerardo Marx
+21/Oct/2026
+Objective:
+- ePWM1 (ePWM1A and ePWM1A) and ePWM2 will be controlled CPU1
+- ePWM4 and ePWM5 will be controlled CPU2
+- CPU1: ePWM1 (GPIO0 and GPIO1 outputs), up-count, 10KHz, and D=0.4
+- CPU1: ePWM2 (GPIO2 and GPIO3), up-down, 5KHz, and m=-0.3
+- CPU2: ePWM4 (GPIO6 and GPIO7), up-count, 15KHz, and D=0.6
+- CPU2: ePWM5 (GPIO8 and GPIO8), up-down, 4KHz, and m=+0.7
+*/
+
+
+#include "driverlib.h"
+#include "device.h"
+
+void main(void)
+{
+
+}